The DEI 519H Three-Channel Receiver does not work with DEI Red LED remotes.

The DEI 519H can be installed inside your vehicle to provide 3 additional channels of output to activate various optional alarm accessories, such as the DEI 530T window roll-up / roll-down.

Its most common use is to add it to your present garage door opener to increase its operating range, have additional remotes and be able to open and close your garage door with your present DEI, Clifford or Avital remotes.

(a) The DEI 519H Three-Channel Receiver will work with any garage door opener that has a wall switch or button to open and close your garage doors. It is easily attached to these same button wires. In effect, it is a 'remote button pusher'.

It has 3 channel outputs, so it can operate one, two, or even three garage doors. Button I will open and close the 1st garage door. Button II will open and close the 2nd garage door. Pressing buttons I &II simultaneously will open and close a 3rd garage door. On board relays enable connecting directly to the 1st garage door. DEI 8616 Mini-Relays are needed to connect a 2nd or 3rd garage door.

The 519H has a 120 Volt AC power adapter to supply 12 Volts DC to the receiver. It plugs into any 120 Volt outlet. Mount the receiver Control Module near the outlet. Connect wires from the Control Module harnesses to the wires that go from your garage door opener to your wall buttons. That's it, your done.

The receiver control module can store up to 12 different DEI rolling code remote transmitters as listed above. So you can add your present remotes to the two remotes that come with the unit.

If you are planning to use your existing DEI, Clifford or Avital Remotes to operate this garage door receiver, for your convenience, we offer the DEI 519H Three-Channel Receiver with only one 471T remote for $59.95. We suggest that you will need at least one remote that is already programmed to the receiver for installation purposes and to verify that the unit works properly.